GDS3710 User Manual
Version 1.0.7.8
Configures the IP address or the domain name of the outbound proxy,
media gateway, or session border controller. It's used by the GDS for
firewall or NAT penetration in different network environments.
If a symmetric NAT is detected, STUN will not work and only an outbound
proxy can provide a solution.
Configures the backup outbound proxy to be used when the “Outbound
Proxy” registration fails. By default, this field is left empty.
Configure which DNS mode will be used to translate the SIP Server FQDN
(Default value is A Record):
• A Record.
• SRV.
• NAPTR/SRV.
Configures the SIP username or telephone number from ITSP.
Note: Letters, digits and special characters including @ are supported.
Configures the Authenticate ID used by SIP proxy.
Sets the Authenticate password used by SIP proxy.
Note: For security reasons, the SIP password is invisible on the web UI.
Select “User=Phone” or “Enabled” from the dropdown list.
If the SIP account has an assigned PSTN telephone number, this field
should be set to "User=Phone". Then a "User=Phone" parameter will be
attached to the Request-Line and "TO" header in the SIP request to
indicate the E.164 number. If set to "Enable", "Tel:" will be used instead of
"SIP:" in the SIP request. The default setting is "Disable".
Registration Expiration
(m)
Sets the registration expiration time.
Default setting is 60 minutes. Valid range is from 1 to 64800 minutes.
Re-register before
Expiration (s)
Specifies the time frequency (in seconds) that the GDS3710 sends re-
registration request before the Register Expiration. The default value is 0.
Range is from 0-64800 seconds.
Sets the local SIP port. Default setting is 5060 for Account 1, 5062 for
Account 2, 5064 for Account 3, 5066 for Account 4.
Chooses the SIP transport protocol. UDP, TCP or TCP/TLS.
Default setting is UDP.
Select the Video stream to be used by the GDS3710 when call is made
from this SIP Account.
Default is Stream 2.
To Next Page
Loading...
Need help?
General
