Grant 20 Series User Manual

29486 Version 1 - December 2009
Page 3
www.grant.co.uk
1. Overview
This document describes the process for configuring the 20xx range of loggers inbuilt Ethernet
adaptor.
Prerequisites
Before proceeding with the installation you will require all of the following:
- A 20xx logger with inbuilt Ethernet, externally powered
- A networked PC that is able to access the network on which you intend to connect the
20xx logger
- An Ethernet connection on the network you wish the SQ20xx logger to reside.
- Before proceeding you must speak to your network administrator to get the following
information regarding the network you will be connecting the SQ20xx logger to:
○ The network gateway
○ The network subnet mask
○ An available IP address.
 This should ideally be a static IP address.
 If a static address cannot be found then the next best would
be an assigned address.
 The worst case would be a leased address with a significant
timeout.
NOTE: One of the above must be found. Failure to do so could result in problems communicat-
ing with the logger in the event of a reset caused by a power failure.
- When you have the details from your network administrator as detailed above note
them down here as they will be required when setting up communications from within
SquirrelView and the logger.
○ IP address. _____._____.______._____
○ Subnet mask _____._____.______._____
○ Network gateway _____._____.______._____

Grant 20 Series Specifications

General

Brand	Grant
Model	20 Series
Category	Data Loggers
Language	English