EN - 14
Check Tire Pressure
See Specifications on page 39.
Check Engine Oil
Refer to Engine Manual.
Check Hydraulic Oil
See Checking Hydraulic Oil Level on
page 35.
Fill Fuel Tank
Fill fuel tank. DO NOT OVERFILL! See Filling
Fuel Tank on page 19.
Connect Battery
Place unit in the service position (see Service
Position on page 24). Connect negative (–)
battery cable to battery (see Battery
Installation on page 25 and perform steps 2
through 4 in the installation section).
Check Blade Level and Blade Pitch
See Leveling the Mower Deck on page 28.
Check Safety Interlock System
See Safety Interlock System on page 16.
Check Function of All Controls
Ensure unit runs and performs properly.
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a
tire without the proper
equipment and experience
to perform the job.
• Do not inflate the tires
above the recommended
pressure.
• Do not weld or heat a wheel
and tire assembly. Heat can
cause an increase in air
pressure resulting in an
explosion. Welding can
structurally weaken or
deform the wheel.
• Do not stand in front or over
the tire assembly when
inflating. Use a clip-on
chuck and extension hose
long enough to allow you to
stand to one side.
WARNING: Safety interlock
system failure and improper
operation of unit can result in
death or serious injury. Test this
system each time unit is operated.
If this system does not function as
described, do not operate until
repairs are made.
To Next Page
Loading...
Need help?
General
