EN - 24
Gravely Dealers will provide any service which
may be required to keep your unit operating at
peak efficiency. Should engine service be
required, it can be obtained from a Gravely
Dealer or the engine manufacturer’s
authorized service center.
SERVICE POSITION
(Figure 8)
IMPORTANT: Place unit on a flat level
surface. ALWAYS shut off engine, set parking
brake, and remove ignition key. Ensure unit is
secure and will not tip over. When a lift is
used, strap and clamp unit to the lift.
1. Place steering levers in neutral position
and engage parking brake.
2. Tip seat forward (see Seat Adjustments
on page 18).
3. Unlatch the hood latches.
4. Using the hood frame handle, slowly lift
the hood up until the hood cable is taunt
and is supporting the weight of the hood.
SERVICING THE BATTERY
NOTICE: Unit comes equipped with a
maintenance-free battery that requires no
regular maintenance except cleaning the
terminals.
Battery Removal
(Figure 9)
1. Place unit in the service position (see
Service Position on page 24).
2. Disconnect negative (–) cable first, then
positive (+) cable.
3. Remove battery hold-down bracket and
battery from unit.
SERVICE AND ADJUSTMENTS
WARNING: AVOID INJURY. Read
and understand entire Safety
section before proceeding.
CAUTION: HOT SURFACES may
result in injury. DO NOT touch
engine or drive parts which are
hot from operation. Allow parts to
cool before servicing.
Figure 8
1. Hood
2. Hood Cable
3. Hood Frame Handle
4. Hood Latches
5. Steering Levers
2
1
3
4
5
Service Position
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
WARNING: Battery posts,
terminals and related accessories
contain lead and lead compounds,
chemicals known to the State of
California to cause cancer and
reproductive harm. Wash hands
after handling.
Figure 9
1. Battery
2. Negative (–) Terminal
3. Negative (–) Cable
4. Positive (+) Terminal
5. Positive (+) Cable
2
4
1
3
5
To Next Page
Loading...
Need help?
General
