EN - 22
For Best Mowing Results
• Cut grass when it is dry.
• Keep mower blades sharp.
• Keep mower deck properly leveled.
• Adjust anti-scalp wheels to prevent
scalping.
• Do not set height of cut too low. For very
tall grass, mow twice.
• Do not travel too fast.
• Mow with engine at full throttle.
• When mulching, only remove 1/3 of grass
length per cutting. Do not cut more than 2.5
cm (1") at a time.
• Discharge clippings into areas already cut.
• Change cutting pattern with each mowing.
• Do not allow grass or debris to collect
inside mower deck. Clean after each use.
STOP THE ENGINE
1. Move steering levers to the neutral
position.
2. Engage parking brake.
3. Reduce throttle to 3/4 fast position.
4. Push PTO switch down to off position.
5. Move throttle control lever to slow
position.
6. Turn key to off position and remove from
ignition.
MOVE UNIT MANUALLY
See Figure 24.
Bypass the transaxles to move the unit with
the engine off.
1. Place unit in service position. See
Service Position on page 23.
2. Turn both transaxle bypass valves 1/4
turn clockwise to the bypass position.
3. Release parking brake and push unit to
desired location.
4. Engage parking brake.
5. Turn both transaxle bypass valves 1/4
turn counterclockwise to operating
position.
6. Return seat to operating position.
TRANSPORT UNIT
1. Push deck lift pedal completely forward to
engage transport lock. Release pedal.
2. Move unit to transport vehicle.
3. Stop engine, engage parking brake,
remove key from ignition and turn fuel
valve to off position.
4. Secure mower frame to transport vehicle.
NOTICE: NEVER secure unit to vehicle from
rods or linkages that could be damaged.
RELEASE TRANSPORT LOCK
1. Push deck lift pedal forward and lift
transport lock release lever.
2. Slowly return mower lift pedal to resting
position.
WARNING: AVOID INJURY.
Wait for all moving parts to stop
before leaving operator’s
position.
Bypass Position
(Transaxles
Disengaged)
Operating Position
(Transaxles
Engaged)
Figure 24
To Next Page
Loading...
Need help?
General
