EN - 23
TIPPING SEAT FORWARD
(Figure 9)
Move steering levers to neutral position and
rotate handles outward. Tip seat forward.
MOWER DECK REMOVAL AND
INSTALLATION
Remove
(Figure 10)
1. Remove PTO belt from the engine drive
pulley. See Replacing PTO Belt on
page 30.
2. Disconnect drag link from the front deck
bracket.
3. Disconnect front and rear trunnions from
the lift arms on both sides of the unit by
removing the 3/8" nuts. Keep hardware
for reinstallation.
4. Slide mower deck out from under unit.
Install
(Figure 10)
1. Slide mower deck under unit.
2. Connect drag link to front deck bracket.
3. Connect front and rear trunnions to the
lift arms on both sides of the unit using
3/8" nuts.
4. Install PTO belt on the engine drive
pulley. See Replacing PTO Belt on
page 30.
5. Level and adjust pitch of mower deck.
See Leveling and Adjusting Pitch of
Mower Deck on page 24.
SERVICE AND
ADJUSTMENTS
WARNING: AVOID INJURY.
Read and understand the entire
Safety section before proceeding.
Figure 9
1. Seat Tipped Forward
2. Mounting Hardware
3. Steering Levers
1
2
3
To Next Page
Loading...
