Operation of wireless remote control
Name and function of wireless remote control
TIMER ON
TIMER ON BUTTON
TIMER OFF BUTTON
ƽ Once press this key to enter into
TIMER OFF setup, in which case
the TIMER OFF icon will blink.
The method of setting is the same
TIMER OFF
as for TIMER ON.
ƽ
Remote control
HEALTH BUTTON
ƽ
Press this button, can set up Health function
on or off. After unit is turned on, Health
function ON is defaulted.
I FEEL BUTTON
ƽPress this button,can set the I FEEL func-
tion on or off. When operating other func-
tion and after signal was sent out,the I FEEL
I FEEL
information will be sent out every 200ms.
After I FEEL function turned on,the remote
control will send the temperature infor-
mation to main control every 10 minutes.
.
AIR BUTTON
ƽ
Press this button, to set up swing angle,
which circularly changes as below:
/&&
This is an universal use remote controller.
If it received the following three kinds of
status, the swing signal is:
When the guide louver start to swing up and
down, if turn off the Swing, the air guide louver
will stop at current position.
which indicates the guide louver swings up
and down between that all five positions.
SWING UP and DOWN BUTTON
Timer On setting: Signal “ON” will blink
and display, signal will conceal, the
numerical section will become the timer
on setting status. During 5 seconds blink,
by pressing ˇ or ˉ button to adjust the
time value of numerical section, every
press of that button, the value will be
increased or decreased 1 minute. Hold
pressing ˇ or ˉbutton, 2 seconds later,
it quickly change, the way of change is:
During the initial 2.5 seconds, ten numbers
change in the one place of minute, then
the one place is constant, ten numbers
change in the tens place of minute at 2.5
seconds speed and carry. During 5s blink,
press the Timer On button, the timer on
setting
succeeds. The Timer On has been
set up,
repress the timer on button, the
Timer On will be canceled. Before setting
the Timer, please adjust the Clock to the
current actual time.
ƽThere is no this function for this unit. If
press this key, the main unit will click,
Some models don't have this function.
but it also runs under original status.
may not to be carried out depending on the actual
models, if press the corresponding
button on the remote control that the unit will not receive this signal and will keep the
original running status.
Notice: This is a universally used remote control shows all the fuctions.Some functions
To Next Page
Loading...
Need help?
General
