Gree FP-204WM-D Service Manual

17
Floor Ceiling Type Fan
Coil Unit Service Manual
CONTROL
● X-FAN
X-FAN button
Press this button to turn on/off the X-FAN function.
The function is not available for this mode.
● - button
Presetting temperature can be decrease the temperature by 1 degree Celsius once. press and hold for
more than two seconds so that we can change the temperature continuously. The minimum and maximum
setting range of the temperature is 16 to 30 degree Celsius.
● + button
Press this button increase the temperature by 1 degree Celsius once. Press and hold for more than two
seconds so that we can change the temperature continuously. The minimum and maximum setting range of the
temperature is 16 to 30 degree.
● TEMP
TEMP button
Press this button to select the display of either indoor setting temperature or indoor ambient temperature.
When the indoor unit powered on rstly, setting temperature display is default. Change status to
to display
the ambient temperature. If received control signal in 5 seconds, the display temp.will revert back to setting
temperature. When unit is off, indoor setting temperature display is default. Note: This function is only available
for certain models.
● TURBO
TURBO button
In Cool or Heat mode, press this button to turn on/off the Turbo function.
● SWING UP AND DOWN BUTTON
Press this button to adjust swing angle, which circularly changes as below:
OFF
This is a universal wireless remote controller; however, the unit covered in this manual is only of the
simplied SWING function. As a result, when the wireless remote controller is energized initially with the unit
under the OFF status, this simplied function should be set by pressing the + button and the SWING button
simultaneously, with the symbol
blinking twice. Then, after the unit is turned on, this function can be activated
or deactivated simply by pressing the SWING button, with the displayed symbol indicating this function is on
and without this displayed symbol indicating this function is off.
● TIMER ON BUTTON
Press the TIMER ON button to set the timed On. Press +/- once to increase or decrease the minute by 1
minute. If pressed and held for 2 seconds, the minute will increase or decrease constantly by 1 minute. If held
constantly for more than 5 seconds, the minute will begin to change in every 10 minutes. Press TIMER ON
again to accept the setting and ON will show besides the time of clock meaning the setting succeeds. Press the
TIMER ON again to cancel the setting.
● TIMER OFF BUTTON
Press the TIMER OFF button to set the timed Off. The procedures are similar as above.
Note: This is a general remote control, it could be used for multiple types (functions) of air conditioners.
For some models without the functions specied here, we preserve the right to not to inform exclusively.

Gree FP-204WM-D Specifications

General

Brand	Gree
Model	FP-204WM-D
Category	Heating System
Language	English