5
INSTALLATION INSTRUCTIONS
CAUTION
When handling the unit be careful to avoid cuts from any sharp metal edges
and the aluminum fins on the front / rear coils.
IMPORTANT: Save these instructions for future reference.
Product failure due to any improper installation is not covered under the One Year Limited Warranty.
IMPORTANT: You MUST use the parts provided for installation as well as proper installation
procedures as described in this manual when installing this unit.
WARNING
• Observe all electrical governing codes and ordinances.
• Do not use damaged or non-standard power cords.
• Use caution during installation and maintenance.
• Use proper operation to prevent electric shock, casualty and other accidents.
• Proper installation is the responsibility of the installer. If not installed properly the warranty is void.
• All parts described must be used with no substitutions.
Selection of Installation Location
Installing the unit in the following places can be dangerous and may cause malfunction:
1. Areas with strong heat sources, vapors, flammable or explosive gas, sulfated gas or volatile objects
spread in the air.
2. Near high-frequency devices such as welding machines, medical equipment, etc.
INSTALLATION INSTRUCTIONS
Requirements for Electric Connection
• Follow the Electric Safety Information when installing the unit.
• According to your local safety regulations, use a qualified power circuit.
• Do not plug into an outlet if it is loose or damaged. It may cause electric shock.
• Please make sure the power supply complies with the requirement of air conditioner. Unstable power
supply or wrong wiring may lead to electric shock, hazard or malfunction. Note: Electricity requirements
are 115V (60 Hz).
• Do not connect to the power outlet before finishing installation.
• Please make sure the outlet is always grounded effectively, otherwise it may cause electric shock.
The grounding resistance should comply with national electric safety regulations.
Before You Begin
To Next Page
Loading...
Need help?
General
