Multi Variable Air Conditioners Console Type Indoor Unit
16
5.2 Preparation before Operation
When using the remote controller for the first time or after replacing the batteries, please set the
time of the system according to current time in the following steps:
(1) Pressing “CLOCK” button,
is blinking.
(2) Pressing “
” or “ ” button, the clock time will increase or decrease rapidly.
(3) Press “CLOCK” button again to confirm the time and return to display current time.
5.3 Introduction of Operation Function
(1) Selecting operation mode.
In unit on status, press “MODE” button to select operation mode in following sequence:
(2) Setting temperature.
In unit on status, press “
” button to increase setting temperature and press “ ” button to
decrease setting temperature. The range of temperature is from 16°C to 30°C.
NOTE!
Under auto mode, manual adjustment of temperature is not needed.
(3) Adjusting fan speed.
In unit on status, press “FAN” button to adjust fan speed in following sequence:
NOTES!
①
When operation mode changes, fan speed is memoried.
②
Under dry mode, fan speed is low and can not be adjusted.
(4) Setting swing function.
1) Setting left&right swing.
A. Under simple swing status, press “
” button to adjust left&right swing status.
B. Under fixed-angle swing status, press “
” button to adjust left&right swing angle
circularly as below:
NOTE!
Operate continuously left&right swing in 2 seconds, swing states will change according to
above-mentioned order, or switch closed state and
state.
2) Setting up&down swing.
A. Under simple swing status, press “
” button to adjust up&down swing status.
B. Under fixed-angle swing status, press “
” button to adjust up&down swing
To Next Page
Loading...
Need help?
General
