Multi Variable Air Conditioners One-way Cassette Type Indoor Unit
13
4.4.2 Panel installation
(1) Remove the grille from the panel, and then open the horizontal louver.
(2) Aim the screw hole on panel at the corresponding screw hole on main unit.
(3) Screw up the screws on corresponding holes and then install the coresponding screw cover.
(4) Close the horizonl lover, connect the butt terminal and arrange the wires.
(5) Install the grille.
Tighten screws
Install screw cap
Grille
Ceiling
Air outlet
⑤
Decoration panel
5-8mm
.
Indoor unit
Sealing mater
4.5 Wired controller installation
Wired controller is optional accessory. If wired controller is needed, please contact your local
dealer and install the wired controller according to the instruction manual.
Note:
Do perform the commissioning operation before rst use, automatic addressing or other settings,
please refer to the manual of ODU.
Copyright 2018. This translation is property of GREE PRODUCTS SL. All rights reserved. Total or partial reproduction without its express authorization is prohibited.
To Next Page
Loading...
Need help?
General
