126
9.3.3 Connection method between duct type IDU and dash receiver
If remote dash receiver is needed for the duct type IDU, it shall be connected through DISP1 and DISP2
in the master board of IDU.
IDU type
Model of remote dash
receiver
Model of connection wire
Corresponding to the interface of
IDU main board
Duct type IDU JS05
Connection wire among plates
(17-core)
DISP1 (connect to 8-core interface)
DISP2 (connect to 9-core interface)
NOTES:
a. Wired controller and remote dash receiver can be used at the same time.
b. When selecting remote dash receiver, select the remote controller.
c. Not suitable for GMV-ND80~140PLS/C-T.
10
EXTERNAL ELECTRICAL WIRING DIAGRAM
10.1 External wiring interface
External wiring interface
Power supply
Quantity 5
Logo L1 L2 L3 N PE
IDU/ODU communication
Quantity 2
Logo D1 D2
Central control
Quantity 2
Logo G1 G2
To Next Page
Loading...
Need help?
General