DC Inverter U-match Series for R410A Unitary Split Air Conditioner
25
4 Maintenance
4.1 Failures Not Caused by Faults of The AC
(1) If your air conditioner fails to function normally, please first check the
following items before maintenance:
Problem Cause Corrective measure
The air
conditioner can't
run.
If you turn off the unit and
then immediately turn it on, in
order to protect the
compressor and avoid
system overload,
compressor will delay
running for 3min.
Please wait for a while.
Wire connection is wrong.
Connect wires according to
the wiring diagram.
Fuse or circuit breaker is
broken.
Replace the fuse or switch on
the circuit breaker.
Power failure.
Restart after power is
resumed.
Power plug is loose. Re-insert the power plug.
Remote control has low
battery.
Replace the batteries.
Bad cooling or
heating effect.
Air inlet and outlet of the
units have been blocked.
Clear the obstacles and keep
the room for the units well
ventilated.
Improper temperature setting Reset a proper temperature.
Fan speed is too low. Reset a proper fan speed.
Air flow direction is not right.
Change the direction of air
louvers.
Doors or windows are open. Close them.
Exposed under direct
sunshine.
Put on curtains or louvers in
front of the windows.
Too many heat sources in the
room.
Remove unnecessary heat
sources.
Filter is blocked or dirty.
Send for a professional to
clean the filter.
Air inlets or outlets of the
units are blocked.
Clear away obstacles that are
blocking the air inlets and
outlets of the units.
To Next Page
Loading...
Need help?
General
