DC Inverter U-match Series Duct Type Unit
3.4 Check after Installation
Check Items after Installation.
Possible events due to improper insta
lation
Is the main body installed
The unit may fall down, vibrate or produce
Did you do water leakage test?
Cooling capacity may become unsatisfactory.
Is the unit well insulated from
Condensate, water drops may occur.
Does water drainage go well?
Condensate, water drops may occur.
Is the voltage consistent with that
The unit may fail or its components may get
Are the wires and pipes installed
The unit may fail or its components may get
Has the unit been safely
Risk of electric leakage.
Do the specifications of wires
comply with the requirement?
The unit may fail or its components may get
Is there any obstacle blocking
the air inlet and outlet of the
Cooling capacity may become unsatisfactory.
Have you recorded the length of
refrigerant pipe and the
refrigerant charging amount?
The refrigerant charging amount can’t be
controlled.
3.5 Test Running
Preparation before connecting the power:
(1) Power must not be connected if the installation work is not completed.
(2) Control circuit is correct and all the wires are firmly connected.
(3) Cut-off valves of the gas pipe and liquid pipe are open.
(4) The inside of the unit should be clean. Take irrelevant objects out if there
is any.
(5) After checking, re-install the front side plate.
Operation after connecting the power:
(1) If all the above works are finished, power on the unit.
(2) If the outside temperature is more than 30°C, heating mode can’t be
enabled.
(3) Make sure the indoor and outdoor units can run normally.
To Next Page
Loading...
Need help?
General
