18
Technical Information
Service Manual
If remote controller is lost or damaged, please use auxiliary button to turn on or turn
off the air conditioner. The operation in details are as below: As shown in the g.
Open panel, press aux. button to turn on or turn off the air conditioner. When the air
conditioner is turned on, it will operate under auto mode.
Emergency Operation
Note:
● During operation, point the remote control signal sender at the receiving window
on indoor unit.
● The distance between signal sender and receiving window should be no more than
8m, and there should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp or
wireless telephone; remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don’t use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there’s no display, please replace
batteries.
1.Press the back side of remote controller marked with“
”as shown in the g, and then push out the cover
of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of “+” polar and “-“ polar are correct.
3. Reinstall the cover of battery box.
Replacement of Batteries in Remote Controller
To Next Page
Loading...
Need help?
General
