Remove
old batteries
Install
new batteries
CHANGING BATTERIES
OPERATION OF WIRELESS REMOTE CONTROLLER
CHANGING BATTERIES AND ADDITIONAL NOTES
To change batteries, slide cover off battery compartment on back of remote controller. Remove
and safely discard old batteries. Insert two new AAA 1.5V dry batteries, using correct polarity.
Reattach back cover.
NOTE:
• If the remote controller will not be used for a long time, remove batteries to prevent
leakage damage.
• Be sure to aim the remote controller at the receiver of the main unit when operating.
• When remote emits a signal, icon will flicker; a tone will be heard when unit receives
that signal.
DAMAGED OR LOST REMOTE CONTROLLER
If remote controller is lost or damaged, the
Sapphire
system
can be turned off directly from
the indoor unit. Lift the front panel of the indoor wall unit, then press the AUX button to turn
on or turn off. When the unit is on, it will operate in AUTO Mode.
16
Use insulated object to press the Aux. button.
WARNING
Aux. Button
Panel
To Next Page
Loading...
Need help?
General
