22
rainage port
In Cool, Dry or Heat mode operating, the condensation water will be drained to
the chassis.
When the chassis is full with water, the buzzer will give out 8 sounds and "H8" is
displayed to remind user to discharge water, the unit will turned off 2min latter,
and all buttons are invalid.
To empty the chassis, please follow the instructions bellow.
. Turn the unit off and unplug from the electrical outlet.
. Use a small pan or move the unit to a suitable place to drain the water.
. Remove the pre-installed drain cap from the unit.
. Drain the water into the small pan or a suitable place.
. Once draining is complete,re-install drain cap.
. Press ON/OFF button to restart the unit.6
Removing Collected Water
There are 2 ways to remove collected water:
1
Use the drainage option from the lower hole.
Wind the power cord around the .
To Next Page
Loading...
Need help?
General
