MAINTENANCE
SERVICING
Servicing should be performed by a qualied technician. Replacement parts for this snow
thrower must be identical to the parts that they replace. If repairs are necessary, contact the
Toll-Free Helpline, at 1-888-909-6757.
Note: Identify the left and right sides of the snow thrower when standing in the normal operating position.
WARNING
If the extension cord is plugged into the Snow Thrower, the snow thrower could start accident
ally while the operator is performing maintenance on it, which could cause serious personal
injury. Disconnect the extension cord before performing any maintenance.
REPLACING THE SCRAPER (See Figure 13)
The scraper is located at the bottom of the impeller housing.
• Ensure that the snow thrower is not plugged in.
• Remove the screw (1) from each side plate that holds the scraper and 3 screws (2) from under
the machine that secures the scraper to the machine.
• Remove and discard the old scraper.
• Install the new scraper, and fasten it securely with the 5 screws that you previously removed.
Fig. 13
21
1
1
1
2
To Next Page
Loading...
Need help?
General
