TRIMMER-Translation of the original instructions
TECHNICAL SPECIFICATIONS
ENGINE: - KAWASAKI FJ180V KAI OHV, 179 cm³ 4,5 HP (@ 3600 r.p.m.), one-cylinder, petrol.
STARTER: recoil starter.
FUEL TANK: 1,7 Litres.
GEARBOX: mechanical with single-speed.
CLUTCH: multiple-disc clutch in oil-bath.
SPEED: 2 km/h.
CUTTING HEIGHT: adjustable at 1,5 – 3 – 5 – 6 cm.
CUTTING WIDTH: 60 cm.
HANDLEBARS: adjustable and foldable.
BRAKES: service and parking mechanical brakes on both wheels.
WHEELS: 38-cm-diameter TRACTOR driving wheels.
AXLE: fixed.
EXTERNAL DIMENSIONS with wheels: 55 cm.
STANDARD FEATURES: grass-guard protection and automatic brake on the cutting organ
ACCESSORIES: anti-skid toothed discs.
WEIGHT: 55 kg
PUTTING THE WHEELED TRIMMER INTO SERVICE
1) Check that the wheeled trimmer has not been damaged in transit.
2) Remove the wheeled trimmer from the packaging, paying attention not to damage lever and
wires. Use an appropriate lifting machine (min. lifting capacity 100 kg).
3) Mount both the side and front protections (fig. 1, n. 16 – 17).
4) Mount the handlebar (fig. 11) by inserting the wire fair-leads into the eyelets and positioning it in
the desired position by fixing the screws (fig. 1, n. 20)
5) Check the tyre pressure: wheels 3.50-8 (2 PLY RATING) 1,1 BAR
6) Fill the tank with fuel (fig. 3, n. 12) using a funnel equipped with a very fine filter.
7) Check the oil level with the machine set in horizontal position (fig. 3, n. 13).
To Next Page
Loading...
Need help?
General
