English (GB)
16
Radio Scan
1. Switch on the power supply to the pump.
2. Connect the MI 301 to the PC.
3. Place the MI 301 at a distance of maximum 10 metres from
the pump.
4. Start PC Tool. The first time the program is started, the
message "No COM port selected" will be shown. Click [OK].
Fig. 37 No COM port selected
5. Select "Preferences" in the main menu under "Files".
6. Open the dropdown menu "Select interface" and select "MI
301". See fig. 38.
Fig. 38 Selecting the user interface
7. Open the dropdown menu "Select port" and select the port
"PCTool-Link". See fig. 38. Click [Apply].
8. Click [Radio Scan]. See fig. 39. Wait until connection has
been established to the products the MI 301 can communicate
with (10-20 seconds).
Fig. 39 Radio Scan
9. Mark the pump to be connected and click [Connect]. See
figures 40 and 41.
Fig. 40 Selection of unit
Fig. 41 Establish connection to the pump
10. Click the button for radio communication. See fig. 42. Status
in PC Tool will change to "Connected". See fig. 43.
Fig. 42 Connection via radio communication
Fig. 43 Connection established
11. Find the GSC file for the motor by means of section
7.15.3 Configuration with the PC Tool E-products.
TM05 6928 0313TM05 7037 0413TM05 6932 0313
TM05 7211 0713TM05 7044 0513TM05 7212 0713
Click [Connect] if the pump is "Unlocked". See fig.
41.
TM05 7039 0412
To Next Page
Loading...
Need help?
General
