English (GB)
17
Direct Connect
1. Switch on the power supply to the pump.
2. Connect the MI 301 to the PC.
3. Place the MI 301 at a distance of maximum 10 metres from
the pump.
4. Start PC Tool. The first time the program is started, the
message "No COM port selected" will be shown. Click [OK].
Fig. 44 No COM port selected
5. Select "Preferences" in the main menu under "Files".
6. Open the dropdown menu "Select interface" and select "MI
301". See fig. 45.
Fig. 45 Selecting the user interface
7. Open the dropdown menu "Select port" and select the port
"PCTool-Link". See fig. 45. Click [Apply].
8. Click [Direct Connect]. See fig. 46. Wait until connection has
been established to the products the MI 301 can communicate
with (10-20 seconds).
Fig. 46 Direct Connect
9. Click the motor button for radio communication. Connection
has now been established.
Fig. 47 Connection via radio communication
10. Find the GSC file for the motor by means of section
7.15.3 Configuration with the PC Tool E-products.
7.15.2 Connection to motor via PC Tool Link
Equipment
• PC Tool E-products, version 14.00.00 or newer
• Grundfos PC Tool Link
• GENIbus cable (RS-485).
Procedure
1. Disconnect the power supply.
2. Remove the terminal box cover. See section 7.1 Replacing
the terminal box cover.
3. Connect PC Tool Link to the GENIbus terminals on the motor
by means of the GENIbus cable.
Fig. 48 Connection of GENIbus
4. Connect the mains supply to the pump.
TM05 6928 0313TM05 7037 0412TM05 7208 0713TM05 7212 0713
TM05 7122 0513
To Next Page
Loading...
Need help?
General
