41
PROGRAMMING THE DISHWASHER
2.2 Saving Energy
2.3 Starting A program
2.4 Changing The Program Mid-cycle
❗
NOTE:
: : The ECO program is suitable to clean normally soiled tableware, that for this use,
it is the most efficient program in terms of its combined energy and water consumption,
and it is used to assess compliance with the EU ecodesign legislation.
1. Pre-rinsing of tableware items leads to increased water and energy consumption and is not
recommended.
2. Washing tableware in a household dishwasher usually consumes less energy and water in
the use phase than hand dishwashing when the household dishwasher is used according to the
instructions.
1. Draw out the lower and upper basket, load the dishes and push them back. It is commended
to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page ”Product fiche”. Make
sure that the water supply is turned on to full pressure.
4. Open the door, Press the Power button.
5. Choose a program, the response light will turn on. Then close the door, the dishwasher will
start its cycle.
A program can only be changed if it has been running only for a short period of time, otherwise
the detergent may have already been released or the the wash water with detergent has already
been drained. If this is the case, the dishwasher needs to be reset and the detergent dispenser
must be refilled. To reset the dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm stopped working, you can
open the door completely.
2. Press Program button more than three seconds the machine will be in program selection
mode.
3. You can change the program to the desired cycle setting.
3 sec
EC O
To Next Page
Loading...
Need help?
General
