ATTENTION: By default, the miniLock ll is set to One-Time-Use Mode (Locker
Mode). The miniLock ll can easily be set to Single User Mode with either of the two
below steps:
1. Before battery tab is removed, hold down # 0 key, pull the tab and key the # 0
key pressed 3 seconds
2. Convert lock to one time use at any time by entering in
MasterCode 1 0
SINGLE USER MODE
OPENING WITH USER PASSWORD:
1) Enter your 4-digit user password.On first use factory default is <1-0-1-0>
2) Rotate handle within 5 seconds to opening direction and there will be a con-
firmation beep.
User Password
1 2
Below illustrations show examples of
lock installed for right handed door. Lock
can be installed for left or right handed
If single user mode is selected (default), press
password.Press button again
and enter new 4-digit user password. Press
button again and approve new
password. You will get a confirmation beep and green LED light will blink.
NOTE: WHAT HAPPENS IF USER FORGETS THEIR PASSWORD?
Locker Mode (Multiple User):
Use Master code to unlock and turn handle to open position. Lock is now ready
for next user to enter in their unique code.
Single User Mode:
1) Use master code to reset the lock to factory defaults.
MasterCode
4 0
2) Default user code is now < 1-0-1-0 > and can be changed.
14
To Next Page
Loading...
Need help?
General
