20 | English
TROUBLESHOOTING
Before contacting the customer service, please check the following
circumstances:
PROBLEM CAUSES SOLUTION
Tumble dryer
fails to operate.
– Poor connection to the
power supply.
– Power failure.
– No drying program is set.
– Device has not been
switched on.
– The water tank is full.
– The door is not closed
properly.
▪
Check connection to the power
supply.
▪
Check the power supply.
▪
Set a drying program.
▪
Switch the device on.
▪
Empty the water tank.
▪
Close the door properly.
Tumble dryer
fails to operate
and the display
shows END.
– The laundry has reached
the condition defined by
the program.
– There is no laundry in the
drum.
▪
Check if the program setting is
appropriate.
▪
Check if there is laundry in the
drum.
Drying time is
too long and
the results are
not satisfac-
tory.
– The program setting is not
correct.
– The filter is clogged.
– The evaporator is blocked.
– The tumble dryer is
overloaded.
– The laundry is too wet.
– The vent duct is blocked.
▪
Make sure the program is set
correctly.
▪
Clean the filter screen.
▪
Clean the evaporator.
▪
Reduce the amount of laundry.
▪
Spin the laundry properly
before drying.
▪
Check the vent duct and
unblock it.
Remaining time
on the display
stops or skips.
The remaining time will be
adjusted continuously based
upon the following factors:
– Type of laundy.
– Loaded amount.
– Moisture degree of the
laundry.
– Ambient temperature.
The automatic adjustment is a
normal operation.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
