Haier HD90-A2939 - Page 24

EN
11-Troubleshooting
Troubleshooting without display-codes
Problem Possible cause Possible solution
Tumble dryer
fails to operate.
• Poor connection to the power
supply.
• Power failure.
• No drying program is set.
• Device has not been switched
on.
• The water tank is full.
• The door is not closed properly.
• Check connection to the pow-
er supply.
• Check the power supply.
• Set a drying program.
• Switch on the device.
• Empty the water tank.
• Close the door properly.
Tumble dryer
fails to operate
and the display
shows .
• The laundry has reached the
dry level defi ned by the pro-
gramme.
• Check the program setting is
appropriate or not.
Drying time is
too long and
the results are
not satisfactory
• The programme setting is not
correct.
• The fi lter is clogged.
• The evaporator is blocked.
• The tumble dryer is overloaded.
• The laundry is too wet.
• The vent duct is blocked.
• Make sure the program is set
correctly.
• Clean the fi lter screen.
• Clean the evaporator.
• Reduce the amount of laun-
dry.
• Spin the laundry completely
before drying.
• Check and clean the vent duct.
Remaining time-
on the display-
stops or skips.
The remaining time will be adjus-
ted continuously based upon the
following factors:
• fabric of laundry.
• loading weight.
• Moisture degree of the laundry.
• Ambient temperature.
The automatic adjustment is a
normal operation.
24