12.6 Wash-dryer stack
It is possible to achieve a washer-dryer stack.
is possible (Fig. 12-8). Not every washing machine is
suitable for this purpose. Stacking information, as
well as the corresponding mounting kit are available
via your local dealer.
The mounting instructions are supplied with the kit
which thoroughly inform the installation steps.
EN
12-Installation
12-8
12.7 level the dryer
Place the gradienter at the centre
Level the dryer side to side(Fig.12-9):
back of the dryer.
level side to side.
Never fully screw the feet completely from
their housings.
Adjust the rear feet until the dryer is
Level the dryer front to back(Fig.12-10):
Place the gradienter on the left side.
Adjust the front left foot (wind down).
Repeat the above for the right foot.
Double check the dryer is balanced(Fig.12-10):
Ensure the dryer does not rock
Place the gradienter at the centre front of the dryer.
in any direction.
If dryer is not balanced repeat the above steps.
After levelling, the corners of the dryer cabinet should be clear of the floor and the dryer.
must not rock in any direction.
26