Troubleshooting
If you take all these checks and the dishwasher still does not function or your dishwasher
have any other error display, you can power the dishwasher OFF, and wait a few minutes.
You can power the dishwasher on, try it again, if the dishwasher still does not function and/
or the problem persists, contact the nearest authorised service center and provide them
with the following information:
Fault with fuse in mains electricity supply.
Plug not inserted in wall socket.
Appliance door not closed properly.
Knob stay at the mark of "RESET"
Water tap not turned on.
Blocked strainer in water intake hose.
- The strainer is situated in the Aquastop or supply-hose connection.
Caution
Do not forget that repairs should only be carried out by a qualified specialist. Improper repairs
can lead to considerable equipment damage as well as danger to the user.
...with the appliance itself
the water is turned on and the hose is connected properly;
the water supply to the house is on and has sufficient pressure;
the water supply hose is crimped or bent;
the filter for the water supply hose is clogged.
the drain hose is too low.
When the alarm sounds in a series of 2 beeps, pause, 2 beeps, pause ...
the drain hose is crimped or bent.
the drain hose is too high.
When the alarm sounds in a series of 3 beeps, pause, 3 beeps, pause ...
When the alarm sounds in a series of 4 beeps, pause, 4 beeps, pause ...
Temperature sensor failed and call your Authorised Service Center.
When the alarm sounds in a series of 5 beeps, pause, 5 beeps, pause ...
Flood switch has been activated and call you Authorised Service centre.
the drain hose is too low.
When the alarm sounds in a series of 6 beeps, pause, 6 beeps, pause ...
When the "END" indicator is on, at the moment, the alarm sounds in a series of 7 beeps,
pause, 7 beeps, pause ...
the door is not properly closed.
10
To Next Page
Loading...
Need help?
General
