Attention:
The plastic hose support must be fastened to the wall to prevent the drain hose from moving.
Electrical Connection
After making sure that the voltage and frequency in the home correspond to those on the rating plate of the
appliance (located on the side of the stainless steel inner door) and that the electrical system can cope with
the maximum voltage on the rating plate,insert thr plug into an earthed electrical socket.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink. Use the
plastic support that comes with the appliance (see fig .2) and ensure there are no tight bends or kinks. The
free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water.
DO NOT USE ADAPTORS OR EXTENSION LEADS.
Installation
fig.2
MAX 100
MIN 40
14
To Next Page
Loading...
Need help?
General
