Notice
Do not place the tablets in the tub or the cutlery basket as this
will result in poorer wash results. The tablets should be placed
in the detergent doser.
12
A cycle that is underway can only be modified if it has been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the
Detergent").
When the buzzer constantly beeps six times, the “End” light will turn on and the cycle has finished. Turn off
the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher.
Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while
they are still hot and more susceptible to breakage. They will also dry better.
Cancelling or modifying a wash cycle setting...
At the end of the wash cycle...
Rotate the knob to the mark of “Reset” then select
right programme.
Wash Cycle Adjustment Buttons
“DRY” Button
This button (see "Close-up View - Control Panel ", letter "A") when press with light wash cycle make it
possible to length the drying phase.
“3 in 1” Button (NOT RECOMMENDED FOR USE IN NEW ZEALAND)
This button (see "Close-up View - Control Panel", letter "B" ) , is used for the customer useing the “3 in
1” detergent.
When using "3 in 1"combination products, the rinse-aid light is no longer useful. It may be helpful there-
fore to switch the rinse aid off.
"ECO" Button
This button (see "Close-up View - Control Panel", letter "C" ) when press with normal wash cycle make
it possible to run the wash cycle at a lower temperature.
To Next Page
Loading...
Need help?
General
