EN
Programme selection
The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as
well as the amount and condition of food remains, with the details contained in the wash cycle table.The
corresponding programme sequence, duration and consumption details are shown in the right half of the
overview. For example:
Use the« Normal Eco» programme for dishes and utensils which have normally soiled items.
Small loads
If only a small number of dishes have been loaded into the dishwasher, selecting the "Half load"
function which should be sufficient.
Programme data
The stated programme data are based on standard operating conditions. The values can vary consider-
ably according to:
different amounts of dishes
temperature of mains water supply
pressure
of mains water supply
ambient temperature
fluctuations in mains voltage
machine-related factors (e.g. temperature, water volume,...)
Switching the dishwasher ON
Turn on the tap.
Close the door after loading the appliance
Set On-Off button “B” to On. The state indicator "A" light.
Rotate the knob to select programme you wish.
The time-remaining indicator display
the time of the programme you selected.
After 3 seconds the appliance emits a short warning signal,
and start the programme, the state indicator "A" blinks .
Warning
When the dishwasher power on, the programme which the knob indicated
can not be carried out, you must Rotate the knob to another programme
and then back to it.
B
A
D F
C
G
E
I
H
18
Washing dishes
To Next Page
Loading...
Need help?
General
