To Next Page

To Previous Page

STEP 2 - CONNECT AND SECURE THE DRAIN HOSE

1. Enlarge the opening by squeezing the

ends of the drain hose clamp together.

Slide the clamp over the end of the drain

hose, and onto the exible section of the

hose.

2. Fit the end of the drain hose over the

plastic drain port extending from the

washer.

3. Squeeze the ends of the clamp to enlarge

the opening and slide the clamp over the

connection of the drain hose and drain

port. Release the clamp to tighten.

4. Put the drain hose hook end in a drain pipe or laundry tub.

5. Secure the drain hose in place by fastening it to a water hose, the standpipe, or a

leg on the laundry tub. See “Drain System Requirements” for illustrations.

STEP 3 - CONNECT THE WATER HOSES

IMPORTANT: Only use new hoses when installing the washer.

NOTE: Periodically inspect hoses for cracks, cuts, leaks or wear. Replace with new

hoses every 5 years.

NOTE: Hot water needs to be set at a temperature of at least 120ºF - 140ºF. (49ºC-

60ºC) for the soap to dissolve and to avoid soap residue remaining on clothes.

1. Check that a at washer is present and rmly in place in each end of the water

inlet hoses. Flat washers are pre-installed at the factory.

Washer

Haier HLP28E User Manual

Questions and Answers: