5
INSTALLATION INSTRUCTIONS
TOOLS NEEDED
Pliers
Wrench
Flat-blade Screwdriver
Measuring Tape
Carpenter’s Level
PARTS SUPPLIED
Drain Hose Clamp
Drain Hose Hook
Drain Hose
Water Hoses (2)
(at washers pre-installed)
User Manual
LOCATION REQUIREMENTS
The washer must be installed on a solid oor to minimize vibration during the
spin cycle. A concrete oor is best.
The oor should be level with maximum slope of 1" (25 mm) under entire washer.
A suitable location is protected from direct sunlight and heat sources such as
radiators, baseboard heaters, or cooking appliances.
Do not install on carpeting.
The location must have a grounded electrical outlet located within 4 ft. (1.2 m) of
power cord on the back of the washer.
Hot and cold water faucets must be present within 3 ft. (0.9 m) of the hot and
cold connections on the washer.
A water heater must supply hot water with a temperature of at least 120°F
(49°C).
The water pressure should be between 20 and 100 psi (138 and 690 kPa).
WARNING
Do not install or operate the washer where it will be exposed to
temperatures below 32°F (0°C). Water remaining in the washer will
freeze and cause damage to the washer.
To Next Page
Loading...
Need help?
General