-7-
l Remove all food.
l Clean and dry the inside as instructed in the direction given above for cleaning.
l Leave the doors open to prevent any unpleasant smells while the refrigerator is not
used.
Cleaning
When cleaning the refrigerator the electric plug must be removed from the power
supply.
Use water or a non-abrasive detergent on a soft cloth and remove the moisture with a
dry soft cloth. Remember to clear the defrost drain at the back just above the glass
cover.
Replacing the light bulb
If the internal light does not work anymore, disconnect then reconnect at once the
device. If the light does not still work, verify if the light bulb is correctly screwed. If in
spite of these tests, there is no light, it is necessary to change the light bulb. Use a 220-
240V~, 10W light bulb.
l Disconnect the appliance;
l Open the light cover (1);
l Undo the defective light bulb anticlockwise.
l Screw the new light bulb clockwise.
DOOR REVERSE
This fridge has been built with the door hinges on the right. If you want to change the opening
direction, please follow the instruction below:
1. Remove the four screws (1) (2) and take away the top.
2. Remove the two screws (3) that hold the upper hinge (4) and take away the upper hinge (4).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the three screws (5) that hold the lower hinge (6) and make sure to remove the
lower hinge(6).
5. Remove the adjustable leg (8) and transfer it to right side.
6. Remove the bolt-pin (7) and reverse the direction of lower hinge (6). Install the lower hinge
(6) into left side with three screws (7).
7. Insert the bolt-pin (7) to the lower hinge (5).
To Next Page
Loading...
Need help?
General
