INSTALLATION
PAGE 2
ENGLISH
F
A
C
E
D
The marks from to
in the figure are the
parts numbers.
The distance between
the indoor unit and the
floor should be more
than 6.5 ft.
The models adopt HFC free refrigerant R410A
more than
4 in.
more than 4 in.
more than 4 in.
more than 8 in.
more than
6 in.
more than 10 in.
more than
24 in.
A
G
Arrangement of piping
directions
Rear left
Left
Rear
right
Right
Below
G
Attention must be paid to
the rising up of drain hose
This picture is for reference only. Your product may look
operation of the unit to the user according to this manual.
Step 1 - Preparation
Required Tools for Installation
Procedure for Selecting the Location
Drill
Wire Snipper
Hole Saw 2 3/4”
Vacuum pump
Soap-and-water solution or gas leakage
detector
Torque wrench
17mm, 22mm, 26mm
Flaring tool
Measuring tape
Level
Micron gauge
Nitrogen
Mini-Split AD-87 Adapter (1/4” to 5/16”)
A - Non-adhesive Tape
B - Adhesive Tape
C - Saddle (L.S.) with screws
F - Insulation
G - Piping hole cover (Included)
than 10ft away depending on radio wave
conditions.)
do not place anything under the unit that
Note:
or stacked.
2) If installing on a high place such as a roof,
with a fence or guard rail around it.
3) If there is a potential for accumulated
-
of refrigerant concentration in the case of
5) Avoid installing the outdoor unit where
-
monia, and sulfurous gas, are produced. If
anti-rust additive to protect the unit coils.
Choose a location where the hot air
discharged from the unit or the operation
noise and will not cause a nuisance to the
carrying the unit into and out of the site.
air inlet and air outlet.
place.
Locate the unit to avoid noise and
discharged hot air will not annoy the
Install units, power cords and inter-unit
and radio sets. This is to prevent
interference to images and sounds.
X XY
Z
For: 09k 12k 18k 24k
Mounting the Outdoor Unit
When mounting the unit to a wall or
roof, take strong winds and other
environmental conditions into
consideration when securing.
Outdoor unit mounting
dimensions (Unit: mm/inch)
XY Z
09k
5 ½”
140
mm
500mm
256mm
12k
5 ½”
140mm
500mm
256mm
18k
113.5mm
583mm
319.5mm
24k
113.5mm
633mm
340mm
Clearances of Indoor and Outdoor Units
To Next Page
Loading...
Need help?
General
