9-Troubleshooting
EN
22
9.2 Troubleshooting with display code
Problem Cause Solution
CLR FLTR
• Drainage error, water is not fully drained
within 6 minutes.
• Clean pump fi lter.
• Check drain hose installation.
• Lock error • Shut the door properly.
• Water level not reached after 12 minutes.
• Drain hose is self-syphoning.
• Make sure that tap is fully opened and water
pressure is normal.
• Check drain hose installation.
• Water protective level error. • Contact the After sales service.
• Temperature sensor error. • Contact the After sales service.
Many occuring problems could be solved by yourself without specifi c expertise. In case
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
▶ Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶ Electrical equipment should be serviced only by qualifi ed electrical experts, because
improper repairs can cause considerable consequential damages..
▶ A damaged power cable should only be replaced by the manufacturer, its service
agent or similarly qualifi ed persons in order to avoid a hazard.
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
:
The remaining wash cycle time will be 1 hour and 25 minutes
:
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 min-
utes
AUTO
Automatic load detection is working; only in some programmes.
The washing cycle is fi nished. The appliance shuts off automatically.
Door is closed because of high water level, high water temperature or spinning cycle.
The buzzer is deactivated
The buzzer is activated
The function keys is closed.The programme changing is invalid.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
