Haier HW50-10F1 User Manual

2929
•Yourmachinemayhaveeitherasingleinlet
(cold)ordoublewaterinlets(cold/hot)basedonits
specications.
White-cappedhoseshouldbeconnectedtocold
waterinletandred-cappedhosetohotwaterinlet
(applicableformachineswithdoublewaterinlets).
•Toeliminatewaterleakagesinpointsofcontact,
1or2nutsareprovidedinthehosepackage
(applicableformachineswithdoublewaterinlets).
Fitthesenutstotheendsofnewwaterinlethoses
onthesideoftab.
•Mountnewwaterinlethosestoa¾˝,threaded
tab.
•Connectthewhite-elbowendofthewaterinlet
hosestothewhite-lteredwaterinletvalveonthe
rearsideofthemachineandthered-elbowend
tored-lteredone(applicableformachineswith
doublewaterinlets).
Tightenplasticpartsofthejunctionsusingyour
hand.
Inuncertainconditions,havetheconnectionworks
bedonebyaqualiedplumber.
•Flowofwaterwithpressureof0,1-1Mpawill
allowyourmachinetooperatemoreefciently.)
(0,1Mpapressuremeansthatmorethan8litres
ofwaterwillowthroughafullyopentapperone
minute.)
•Ensurethatpointsofcontactdonotleakby
tappingthetapcompletelyaftercarryingmaking
theconnections.
CHAPTER -3: INSTALLATION OF THE MACHINE
(WATER INLET HOSE CONNECTION)
3/4”
10mm

Haier HW50-10F1 Specifications

General

Brand	Haier
Model	HW50-10F1
Category	Washer
Language	English