9-Troubleshooting
EN
22
9.2 Troubleshooting with display code
Problem Cause Solution
• Drainage error, water is not fully drained
within 6 minutes
•
• Check drain hose installation.
• Lock - error. • Shut the door properly.
• Water level not reached after 8 minutes.
• Drain hose is self-syphoning..
• Make sure that tap is fully opened and water
pressure is normal.
• Check drain hose installation.
• Water protective level - error.. • Contact the After sales service.
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
▶ Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶
improper repairs can cause considerable consequential damages..
▶ A damaged power cable should only be replaced by the manufacturer, its service
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle. No
measures must be performed.
Code Message
The remaining wash cycle time will be 1 hour and 25 minutes
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 min-
utes
1/2/3 additional rinses are choosen (see FUNCTION BUTTONS “Extra rinse“).
Function child lock is activated
Door is closed because of high water level, high water temperature or spinning cy-
cle.
The buzzer is deactivated
The buzzer is activated
Function “Speed up” is activated
To Next Page
Loading...
Need help?
General
