4
Adjust the installation position
Adjust the adjustable foot:
Installation and adjustment
Back
Front
Screw
Bottom
plate
Soft items
Install the bottom plate
After opening the package, please lean
the washing machine gently down on soft
items(like to welcloth,blanket,etc.).Install
the bottom plate to the bottom of the
machine with eight screws by across
screwdriver, then lift the machine up
gently. See to the figure:
The largest allowed slope of the base of the machine is 2 . The slanting or rough ground will
result in unstable running or stoppage of the machine. Please adjust it with following methods:
1.Your washer has 2 leveling legs, which are located on the front bottom corners.
2.After properly placing your washer in its final position, you can level your washer.
3.Leveling legs can be adjusted by turning them counterclockwise to raise your washer or
turning them clockwise to lower your washer.
WARNING：Leveling of washer is very important to prevent vibration during spin.
High Low
the adjustable leg
Confirm it's horizontal:
Hang the lead line to confirm
if it is horizontal.
To Next Page
Loading...
Need help?
General