Start-up Page EN-22
Set up the chest freezer and
align
1. Place the chest freezer on a base that is
as flat and firm as possible.
2. Check the position with a spirit level.
3. Level out any unevenness on the ground
using both of the front levelling screws. To
do this
– close the lid.
– tilt the chest freezer slightly to the right.
– twist the levelling screws in or out until
the chest freezer is vertically level and
set the chest freezer straight back down
again.
4. Check the alignment with a spirit level.
When opening the lid, the chest freezer
should not shift.
Connecting the chest freezer
NOTICE
Risk of damage!
The coolant must be allowed to settle
before connecting.
■ After transport leave the appliance to
stand for 2 hours.
• Connect the mains plug to a properly
installed socket (see "Technical specifica-
tions" on page EN-28). The Power light (7)
illuminates.
To Next Page
Loading...
Need help?
General
