Hardi N Series User Manual

15HARDI
®
N-SERIES 3-PT SPRAYER DIAPHRAGM OPERATOR'S MANUAL
3.2 Installation Of P.T.O. Shaft (continued)
3. If P.T.O. shaft must be short ened, pull the shaft apart. Fit the two
shaft parts at tractor and spray er pump and measure how much it is
necessary to shorten the shaft. Mark the protection guards.
Note: The shaft must al ways have a minimum over lap of 6" (150 mm)
(Fig. 3).
4. Shorten the two parts equal ly. Use a saw, and fi le the profi les
af ter wards to re move burrs (Fig. 4).
5. Grease the profi les, and reas sem ble the male and female parts.
6. Fit the shaft to tractor and spray er pump.
Note: Female part to wards tractor. Fit the chains to prevent the
pro tec tion guards from r
otating with the shaft.
7. To ensure long life of the P.T.O. shaft, try to avoid work ing an gles
great er than 15° (Fig. 5).
min. 3/4" (20mm)
Fig. 4
Fig. 3
min. 3/4" (20mm)
min. 6" (150mm)
Fig. 5

Hardi N Series Specifications

General

Brand	Hardi
Model	N Series
Category	Paint Sprayer
Language	English