#135-S-19b-6.2
FUELS: WOOD PELLET FUEL OR UP TO A 50% CORN/PELLET MIX ONLY.
USA Canada
Sides (A) 6” 8” (20cm)
Back (B) 1” 1” (2.5cm)
Front (C) 6” 18” (46cm)
A
A
B
C
USA Canada
(A) 6” 8” (20cm)
(B) 1” 1” (2.5cm)
(C) 6” 18” (46cm)
135-S-19b-6.2
* Measured From Glass
*
Tested &
Listed By
352 Mountain House Road
Halifax, PA 17032
www.harmanstoves.com
This heating appliance does not just have automatic ignition, it has total automatic temperature control. The Advance uses
a small room sensor rather than a wall thermostat for a more accurate temperature control.
The Advance's control panel is designed for easy and efcient operation. It has 2 automatic modes of operation and 2
manual modes of operation. The Advance's specially designed burn pot and the "Advance Igniter" Automatic Ignition
System, allow the unit to burn a large variety of biomass fuels with varying ash content. The Advance feed system has a
maximum feed rate of 6 lbs. per hour and a minimum (maintenance) feed rate of 1.0 lbs. per hour.
This 0 to 48,000 BTU pellet stove has an accordion style heat exchanger system that allows maximum surface area for
the most efcient heat transfer in a smaller rebox.
The unit has an easy to clean combustion system with an ash pan that holds ash from 1 ton of burned premium pellets.
This unit is equipped with several different safety devices which will be explained later in this manual.
SAFETY NOTICE: IF THIS HARMAN ADVANCE PEL-
LET STOVE IS NOT PROPERLY INSTALLED. A HOUSE
FIRE MAY RESULT. FOR YOUR SAFETY, FOLLOW THE
INSTALLATION DIRECTIONS. CONTACT LOCAL BUILD-
ING OR FIRE OFFICIALS ABOUT RESTRICTIONS AND
INSTALLATION INSPECTION REQUIREMENTS IN YOUR
AREA.
Please copy
your serial
number
from the label on your stove to
the box below.
Note: This appliance is also approved for
installation into a shop.
Advance Pellet Stove
Omni-Test Laboratories
Pellet Burning Room Heater
ASTM E1509-04, ULC S627-00 and
ULC C1482-M1990. In accordance with OAR 814-
23-900 through 814-23-909
135-S-19b-6.2