Harman crown DSi Series User Manual

~CTOUJn·
DSi Series Power Amplifiers
'Bl ovHARMAN
--------------------------------------------------
2 Setup
page6
2.1 Unpack Your Amplifier
Please unpack and inspect your amplifier for
any damage that may have occurred during
transit. If damage is found, notify the
transportation company immediately. Only you
can initiate a claim for shipping damage. Crown
will be happy to help as needed. Save the
shipping carton as evidence of damage for the
shipper's inspection.
We also recommend that you save all packing
materials so you wi 11 have them if you ever need
to transport the unit. Never ship the unit
without the factory pack.
YOU WILL NEED (not supplied)
• Input wiring cables
• Output wiring cables
• HD-15 connector (if desired)
• Rack for mounting amplifier (or a stable
surface for stacking)
WARNING: Before you start to set up
your amplifier, make sure you read A
and observe the Important Safety ·
Instructions found al the beginning
of this manual.
2.2 Install Your Amplifier
CAUTION: Before you begin, make sure
your amplifier is disconnected from the A
power source, with the power switch in
the "off" position and all level controls
turned completely down (counterclock-
wise).
Use a standard 19-inch (48.3 cm) equipment
rack {EIA RS-31 OB) See Figure 2.1 for amplifier
dimensions.
You may also stack amps without using a
cabinet.
NOTE: When transporting, amplifiers should be
supported at both front and back.
2.3 Ensure Proper Cooling
When using an equipment rack, mount units
directly on top of each other. Close any open
spaces in rack with blank panels. DO NOT block
front or rear air vents. The back of the rack
should be open.
Figure 2.2 illustrates standard amplifier airflow .
Figure 2.1
Dimensions
~-
3.5ln.
~III., ~- ! 8.9 cm
••• ·--a--
I..__ _____ 19In. ------I
48.3 cm
OSi 1000
OSi 2000
0Si4000
OSi 6000
Figure2.2
Airflow
Operation Manual

Harman crown DSi Series Specifications

General

Brand	Harman
Model	crown DSi Series
Category	Amplifier
Language	English