Harman crown DSi Series User Manual

~CTOUJn ·
\Si ov HARMAN
5 Troubleshooting
Thermal
Clip
- 10
]
- 20
]
Signal
~
Re ady
-
Th er mal
Clip
-10
- 20
Si gn al
R ead y
•
•
Power
Th erma l
Clip
-10
- 20
Signa l
Re a dy
page 18
CONDITION: Normal operation.
• This is normal operation for your amp.
CONDITION: Distorted sound.
• Input signal level is too high. Turn down your amplifier
Level controls. NOTE: Your amplifier should never be
operated at a level which causes the Clip LEDS to
illuminate constantly.
CONDITION: No power to the amplifier .
• The amplifier's Power switch is off.
• The amplifier's power cord is unplugged.
CONDITION: No sound.
• The amplifier is in "fault" mode. A Fault status can be
triggered when one of the amplifier's protection circuits
is activated. First disconnect your speakers from the
affected channels(s) one by one to determine if one of the
loads is shorted. If the indicators return to normal status,
then try a different speaker or cable to determine where
the short is occurring. If no short can be found, turn off
the amp and allow the amp to cool. If indicators do not
return to normal after restarting your amp, check the fuse
and replace if necessary, or return amp to Crown or an
authorized Crown Service Center for servicing.
•
Power
•
T he rmal
Clip
- 10
-2 0
Si g nal
Re a dy
T herma l
Clip
- 10
- 20
Sign al
Ready
Th e rm al
Clip
- 10
-2 0
Signal
Re a dy
DSi Series Power Amplifiers
CONDITION: No sound.
• The amplifier has just turned on and is still in
the 4-second turn-on delay.
• Channel is in thermal protection.
• No input signal
• Input signal level is very low.
• Level controls are turned down.
• Speakers not connected.
Operation Manual

Harman crown DSi Series Specifications

General

Brand	Harman
Model	crown DSi Series
Category	Amplifier
Language	English