13
even enters the signal input. This will suppress the program material preceding this loud passage. The 1066 will
THENBEGINTORECOVERFROMCOMPRESSIONRELEASEBEFORETHELOUDPASSAGEHASDROPPEDBACKDOWNTOWARDTHESET
threshold. This will cause the output level to surge higher as the note or passage should be decaying.
Installation Considerations
(OOKUPSAND#ABLING4HEISDESIGNEDFORNOMINALD"6ORD"ULEVELS4HECANBEUSEDWITH
either balanced or unbalanced sources and the outputs can be used with either balanced or unbalanced loads,
provided the proper cabling is used.
A balanced line is defined as two-conductor shielded cable with the two center conductors carrying the same
signal but of opposite polarity when referenced to ground. An unbalanced line is generally a single-conductor
shielded cable with the center conductor carrying the signal and the shield at ground potential.
.ORMAL"ALANCED#ONNECTIONSFOR)NPUTSAND/UTPUTS
Connection 8,2 423v*ACK
'ROUND 0IN 3LEEVE
(IGH 0IN 4IP
,OW 0IN 2ING
.ORMAL5NBALANCED#ONNECTIONSFOR)NPUTSAND/UTPUTS
Connection 8,2 423v*ACK 43v*ACK
'ROUND 0IN 3LEEVE 3LEEVE
(IGH 0IN 4IP 4IP
,OWGROUND 0IN 2ING 3LEEVE
Tie pin 3 to the ground for unity gain in/out of the 1066 when using unbalanced input connections to bal-
anced output connections or balanced input connections to unbalanced output connections. To do other-
wise won’t hurt the unit but will result in unmatched input to output levels, and the level control will not
be properly calibrated.
The following cable wiring diagrams may to assist you with input and output connections for both balanced and
unbalanced connectors.
Installation Considerations
To Next Page
Loading...
Need help?
General
