12
ZonePRO
TM
Section 4 - Zone Controllers
4.1 ZC Descriptions
The dbx Zone Controllers (ZCs) provide a user friendly solution for controlling different
functions of the ZonePRO processors. The following section provides a description of each of
these ZC models.
VOLUME
0
1
2
3
4
5
6
7
8
9
10
ZC-1 – The ZC-1 is a programmable zone controller that allows input or output volume
level control from a wall panel.
VOLUME
0
1
2
3
4
5
6
7
8
9
10
MUTE
ZC-2 – The ZC-2 is a programmable zone controller that allows output volume level and
mute control from a wall panel.
A
B
C
D
SELECT
A
B
C
D
ZC-3 – The ZC-3 is a programmable zone controller that allows control of source selection,
page steering, or scene selection via a four position rotary control.
The ZC-3 must be assigned as ID#1 and connected to the ZonePRO’s top ZC Input
connector for scene selection control.
1
+V
2 3 4 INOUT
ZC-4 – The ZC-4 is a programmable zone controller that allows control of source selection,
page steering, or scene selection via contact closure.
The ZC-4 must be assigned as ID#1 and connected to the ZonePRO’s top ZC Input
connector for scene selection control.
1 2 3
4 5 6
ZC-BOB – The ZC-BOB allows parallel (also known as “home run”) cabling of the Zone
Controllers.
Each ZonePRO device can accommodate up to two ZC-BOBs. Daisy chaining ZCs off
the ZC-BOB is not supported!
Zone Controllers
Section 4
To Next Page
Loading...