39
ZonePRO
TM
Notes - Nightclub Application
1. The ZonePRO 640 devices are located in the manager’s office.
2. The ZCs in the nightclub are situated near the bar and allow source selection and volume control.
3. The Cossover is used to separate the frequencies for the main and sub speakers in the
nightclub.
4. Output Delay is used to delay the signal from the nightclub area so it arrives at the
same time as the acoustic signal from the nightclub.
5. The restaurant receives the signal from the nightclub allowing it to be sent to the
entire restaurant.
6. The zone controllers in the restaurant provide source selection for the restaurant,
patio, waiting area, and restrooms, and volume control over the restaurant zone.
7. Automatic Gain Control is used in the patio, waiting area, and restrooms to keep the
level of each zone consistent.
8. Output EQ is used in all zones to make the system sound as good as possible.
Section 7
Application Guide
To Next Page
Loading...
General