Harman JBL BAR 5.0 MULTIBEAM User Manual

1010
5.2 Bluetooth connection
Through Bluetooth, connect the soundbar with your Bluetooth
device, such as a smartphone, tablet and laptop.
Settings Bluetooth
Bluetooth
DEVICES
JBL Bar 5.0_xxxx
Now Discoverable
Connected
< 10 m / 33 ft
BT PAIRING
Connect a Bluetooth device
1. Press to switch on (See “6.1 Power-on/Auto standby/Auto
wakeup” in the “6. SETUP” chapter).
2. To select Bluetooth source, press on the soundbar or on
the remote control.
→ “ ”: Ready for BT pairing
3. On your Bluetooth device, enable Bluetooth and search for
“ ” within three minutes.
→ Successful connection: The device name is displayed
if your device is named in English. A conrmation tone
is heard.
To reconnect the last paired device
Your Bluetooth device is retained as a paired device when the
soundbar goes to standby mode. Next time you switch to the
Bluetooth source, the soundbar reconnects the last paired
device automatically.
To connect to another Bluetooth device
3S
1. In the Bluetooth source, press and hold on the soundbar or
on the remote control until “ ” is displayed.
→ The previously paired device is cleared from the soundbar.
→ The soundbar enters the Bluetooth pairing mode.
2. Follow the Step 3 under “Connect a Bluetooth device”.
• If the device has ever been paired with the soundbar, rst
unpair “ ” on the device.
NOTES:
− The Bluetooth connection will be lost if the distance between the
soundbar and Bluetooth device exceeds 33 ft (10 m).
− Electronic devices may cause radio interference. Devices that
generate electromagnetic waves must be kept away from the
Soundbar, such as microwaves and wireless LAN devices.
5.3 Connection with your home network
Through Wi-Fi or an Ethernet cable, connect the soundbar to
your home network. With Chromecast built-in™, AirPlay and
Alexa supported, the soundbar allows you to stream audio on
smartphones or tablets through the soundbar speakers.
1. On the soundbar, enter the Wi-Fi setup mode:
• Press to switch on (See “6.1 Power-on/Auto standby/
Auto wakeup” in the “6. SETUP” chapter).
→ If the soundbar has not been connected to a network,
the screen shows “ ” and then, “ ”.
• To re-enter the Wi-Fi setup mode, press and hold until
“ ” is displayed.

Harman JBL BAR 5.0 MULTIBEAM Specifications

General

Brand	Harman
Model	JBL BAR 5.0 MULTIBEAM
Category	Speaker System
Language	English