6
DO NOT BURN WET COAL
First, a note to you, the customer.
This section on Assembly is in the manual for
your information should you ever need to move
your unit and to help you understand how each
part is installed.
Harman Home Heating recommends that your
dealer complete the assembly of this stove. It is
also recommended to take a draft reading with the
stoker burning. This reading should be recorded
on the warranty coupon when you activate your
warranty.
Begin assembly by sliding the pusher block with
the adjuster rod from the front through the slot
shown in g.1. Be sure the pusher block is turned
with the bolt hole to feed indicator side.
Next, hold the pusher block in the most rearward
position and slide the adjuster tube over the adjuster
rod until it bottoms out on the pusher block. Thread
the adjuster over the adjuster rod. Thread wing nut
onto the end of the adjuster rod.
To Next Page
Loading...
Need help?
General
