After start-up, the system starts with the most
recently set volume if this does not exceed the
default maximum volume when it is switched on.
⇒Page 31.
Dependent on the country and device, the device
is switched off automatically when the engine is
turned off or the vehicle key is removed from the
ignition lock. When the device is switched on
again, it is switched off again automatically after
approx. 30 minutes (timeout).
Energy management
If battery voltage decreases below the minimum
on-board voltage supply with ignition switched
off, an alarm sounds and
LOW BATTERY is
displayed. The device should be switched off.
If the battery voltage decreases further,
RADIO OFF
is displayed for a short time, and the device
switches off automatically.
Anti-theft encoding
Dependent on the country and device, the device
is protected against theft and unauthorized use
by a security code.
The security code of anti-theft encoding remains
saved in the vehicle after initial entry (comfort
radio encoding). If the anti-theft encoding must be
canceled manually, e.g., when the device is
installed in a different vehicle, please contact a
Volkswagen Partner.
If the vehicle battery is disconnected, switch on the
ignition before you switch the device on again.
Change the basic volume
First read and observe the safety notes
on page 3 and the introductory
information on page 7.
Volume changes are displayed on the screen by a
"ba
r". The device is blocked against operation
during that time.
A few volume settings and adjustments can be set
as default values Page 31.
⇒
Increase, reduce or mute the volume
Vo
lume control ⇒Fig. 1 Rotate clockwise.
Increase the volume
Decrease the volume
Mute
OR
: Pr
ess the
button on the multifunction steering wheel
⇒Manual Operating instructions.
Volume control
⇒Fi
g. 1 Rotate counterclockwise. OR: Press the
button on the multifunction steering wheel ⇒Manual Operating
instructions.
Volume control
⇒Fi
g. 1 Rotate counterclockwise until
is displayed.
OR: Press the
MUTE device button.
When the device is muted, the currently played media source is
paused.
is displayed on the screen.
If the basic volume was increased greatly for
an
audio source, reduce the volume before
you switch to another audio source.
8 Function description
To Next Page
Loading...
Need help?
General