25
P68 Pellet Stove
1. Scrape the top holed surface and sides of the burn
pot.(Fig 33) It is not necessary to completely remove all
of the loosened material from the burn pot. The excess
will be pushed out during the next use.
2. Loosen the (2) wing thumb screws on the lower front
angle of the burn pot. (Fig. 34)
3. Lift off the clean-out cover (Fig.35) to open the bottom
clean-out chamber. (Fig.36)
4. Clean ash buildup from inside the chamber while
cover is off. Use the scraper to tap on the top front
edge of the burn pot. This will help knock pieces of ash,
loosened by the scraping process, down through the
holes. It also helps knock scale off of the igniter element.
The igniter is made to be removable for service
by insulated male/female wire connectors. These
connections between the hot leads (the wires inside the
burn pot) and the cold leads (the wires from the control
board) are always pulled to the inside rear of the feeder
body.
It is very important that these connections are to the
inside rear of the feeder body. Also, the extra wire of
the igniter wire service loop must be pulled out through
the rear of the feeder and tied up so that it will not be
caught and/or damaged by any moving parts.
DANGER
Disconnect the power to the unit before
removing cover.
Fig. 34
Loosen wing screws
Fig. 35
Fig. 36
Igniter Element
Igniter hot lead wires
(high temperature)
Viewed from below through the ash pan opening.
To Next Page
Loading...
Need help?
General
